Amtrak Cascades

Encyclopedia : A : AM : AMT : Amtrak Cascades

---

---

 

The Amtrak Cascades is a passenger train route operated by Amtrak in partnership with the states of Washington and Oregon in the Pacific Northwest of the United States and Canada. The corridor runs 156 miles (251 km) from Vancouver, British Columbia south to Seattle, Washington, continuing 310 miles (499 km) south via Portland, Oregon to Eugene, Oregon. Track capacity in British Columbia does not yet allow for through travel between the two ends, but Thruway Motorcoach connections in Seattle allow for trips between Vancouver, BC and Eugene.

Cascades service on the Seattle-Portland route began in 1993. Total Amtrak Cascades ridership for 2005 was 636,892.[link]

Equipment

The Amtrak Cascades is a unique train that is painted in a special scheme. The train is operated in a push-pull configuration with an EMD F59PHI at one end, and a de-motored EMD F40PH locomotive called a Non-Powered Control Unit (NPCU), or Cab Control & Baggage Car (CCB), nicknamed "Cabbages" on the other end. The NPCU/CCB contains a cement weight, possibly to meet FRA weight requirements.

The passenger cars themselves are produced by Talgo, the only cars by that company in operation in the United States. These cars are designed to passively tilt into curves, allowing the train to pass through them at higher speeds. The Talgo trainset is articulated – each passenger car in the Talgo set actually shares a single axle with the next, such that they cannot be decoupled without lifting one car onto a support. This design can also reduce jackknifing in a derailment.

Funding

Funding for the route is provided separately by the states of Oregon and Washington, with Union Station in Portland serving as the dividing point between the two. As of July 1st 2006, Washington State will fund four daily round trips between Seattle and Portland. Washington State also funds two daily round trips between Seattle and Bellingham, with one of them extending north to Vancouver, BC. Oregon funds two daily round trips between Eugene and Portland. The five trainsets are organized into semi-regular operating cycles, but no particular train always has one route.

Local partnerships

As a result of Cascades service being jointly funded by the Washington and Oregon departments of transportation, public transit agencies and local municipalities can offer a variety of discounts. Please note that companion ticket coupons do expire, have blackout dates, and must usually be presented at a staffed station to purchase a ticket.

• [FlexPass] and University of Washington [UPass] holders receive a 15% discount (code H610) on all regular Cascades travel. Employers participating in these programs may also receive a limited number of free companion ticket coupons for distribution to employees.
• The Sound Transit [RailPlus program] allows riders to use weekday Cascades trains between Everett and Seattle with the Sounder commuter rail fare structure.
• The [Chinook Book] coupon book offers a companion ticket coupon which does not require any particular origination/destination, and is valid until the end of 2006. The Chinook Book costs between $15 and $20.

The Cascades service also benefits from Sound Transit's track upgrades for Sounder service, notably the upcoming Point Defiance Bypass project.

Future plans

The [WSDOT Rail Office] plans for eventual service of 13 daily round trips between Seattle and Portland and 4-6 round trips between Seattle and Bellingham, with four of those extending to Vancouver, BC. Due to a vote by the Washington State Legislature in 2005, the fourth round trip between Seattle and Portland is scheduled to begin operating on July 1st, 2006.

These reductions in travel times are also planned:

• Seattle to Portland – 3:30 (2006); 2:30 (planned)
• Seattle to Vancouver BC – 3:55 (2006); 2:57 (planned)
• Vancouver BC to Portland – N/A (2006); 5:37 (planned)

In order to increase train speeds and frequency to meet these goals, a number of incremental track improvement projects must be completed. Gates and signals must be improved, some grade crossings must be separated, some track must be replaced or upgraded and station capacities must be increased. In order to extend the second daily Seattle to Bellingham round trip to Vancouver, BNSF must make track improvements north of the US-Canadian border, to which the government of British Columbia has been asked to contribute financially.

Vancouver to Seattle projects

[

• Adds a siding to allow freight trains to move off the mainline for Customs inspections; increases reliability for Vancouver to Seattle trains.
• Construction begins in Fall 2007 with expected completion in Summer 2009.

[

• Increases passenger train speeds near the Georgia Pacific plant from 20mph to 30mph.
• Upgrades warning and crossing equipment to improve safety for pedestrians and vehicles at Laurel and Central streets.
• Construction begins in 2008 with expected completion in 2009.

[

• Relocates 0.75 miles of BNSF track to avoid the current sharp curve.
• Would increase passenger train speeds (presumably above 30mph).
• Construction begins in Fall 2007 with expected completion in Summer 2009.

[

• Adds a siding to allow southbound trains from Bellingham to pass northbound trains from Seattle; allows for earlier southbound departure.
• Construction began in 2005 with expected completion in 2007.

[

• Lengthens and repairs siding to ensure freight trains are accommodated; increases reliability for Vancouver and Bellingham to Seattle trains.
• Construction begins in 2007 with expected completion in 2009.

[

• Realigns sharp curves to increase passenger train speeds from 30mph to 50mph, resulting in a two minute time savings to Bellingham and Vancouver.
• Upgrades warning and crossing equipment to improve safety for pedestrians and vehicles at Pacific/Chestnut crossing and Railroad Avenue crossing.
• Construction is hoped to begin in September 2006 with expected completion in June 2007.

[

• Allows more trains to access the station at one time.
• Construction begins in Summer 2006 with expected completion in Winter 2011.

Seattle to Portland projects

[

• Partnership with Sound Transit to bypass BNSF Railway Puget Sound shore track for an alignment between Tacoma at the north end and the Nisqually River at the south.
• Increases train speeds in this corridor with a straighter track alignment.
• Eliminates the need for Cascades trains to use the single-track Nelson Bennett Tunnel, although Coast Starlight trains will likely continue to use the coastal alignment due to the steep grade from Tacoma to Lakewood.
• First phase decreases travel time through the corridor by 6 minutes; second phase decreases travel time by at least another 5 minutes.
• Sound Transit [construction] was originally scheduled to be complete in late 2007 or early 2008, but was delayed: The F59PHI locomotives used by Sounder Commuter Rail cannot climb the steep grade south of Tacoma in wet weather, so a different design to level the incline must be used. Funding for WSDOT's portion of the project has been moved forward by four years to 2007 so their construction may coincide with Sound Transit's. As a result, WSDOT construction is scheduled to begin in 2007 with an anticipated completion date in 2009.

[

• Constructs a third mainline from Kelso to Martin's Bluff, allowing for more frequent passenger service.
• Upgrades warning and signal equipment at four crossings, improving safety for vehicles and pedestrians.
• Construction is scheduled to begin in 2009 with an anticipated completion date in 2013.

[

• Constructs a double-tracked bypass alignment to decrease freight congestion and to increase passenger train reliability.
• Constructs a crossing over the tracks at W. 39th St, increasing vehicle and pedestrian safety.
• Construction is scheduled to begin in 2007 with an anticipated completion date in 2011.

High-speed crossovers

These projects allow trains to switch mainlines at higher speed, reducing time lost when passing another train.

• [Titlow]
• [Ketron]
• [Centennial]
• [Tenino]
• [Chehalis]
• [Newaukum]
• [Winlock]

Grade separations

These projects remove a crossing by creating either a rail or road bridge, allowing for higher train speeds and the best possible crossing safety.

• S. Lander street(Seattle)
• Royal Brougham SR 519 Phase 2 (Seattle)
• S. 212th street(Kent)
• Willis street(Kent)

Station stops

Northbound trains are even-numbered; southbound trains are odd.

All station stops are made.

British Columbia

• Vancouver

Washington

Bellingham

Mount Vernon

Everett

Edmonds

Seattle

Tukwila

Tacoma

Olympia-Lacey

Centralia

Kelso-Longview

Vancouver

Oregon

Portland

Oregon City

Salem

Albany

Eugene

{| class="toccolours" border="1" cellpadding="4" style="margin: 0 auto; border-collapse: collapse; text-align: center;" width=50% |- style="background:#F0F0F0;" ! Amtrak routes |- style="text-align: center;" |Northwest

Amtrak Cascades - Coast Starlight - Empire Builder

References

• [Amtrak Cascades timetable] (PDF) Retrieved December 1st, 2005
• [Amtrak Cascades Draft 20-year Plan] (Washington State) (PDF) Retrieved June 25th, 2006
• [Washington State Department of Transportation Rail Page] Retrieved September 19th, 2005
• [2005 Washington State Transportation Tax Package] Retrieved September 19th, 2005
• [WSDOT Public Transportation and Rail Monthly Report - April 2005] Retrieved September 20th, 2005
• [WSDOT December 2005 Quarterly Project Report for PA Junction Curve Realignments and Delta Yard Storage Tracks] Retrieved March 3rd, 2006

External links

• [Amtrak - Amtrak Cascades] (Amtrak official site)
• [Amtrak Cascades] (Washington State official site)

 

---

From Wikipedia, the Free Encyclopedia. Original article here. Support Wikipedia by contributing or donating.
All text is available under the terms of the GNU Free Documentation License See Wikipedia Copyrights for details.

---

Search Titles

0

1

2

3

4

5

6

7

8

9

A

B

C

D

E

F

G

H

I

J

K

L

M

N

O

P

Q

R

S

T

U

V

W

X

Y

Z

?