Caproni Ca.4
Encyclopedia : C : CA : CAP : Caproni Ca.4
The Caproni Ca.4 was an Italian heavy bomber of the World War I era.
Development
After designing the successful Caproni Ca.3 heavy bomber, Gianni Caproni of the Caproni works designed a much bigger aircraft. It shared the unusual layout of the Caproni Ca.3, being a twin-boom aircraft with one pusher engine at the rear of a central nacelle and two tractor engines in front of twin booms. The most distinguishing feature of the new plane was, that it was built in a rare triplane layout, instead of the more common biplane.
The huge new bomber was accepted the Italian Army under a military designation Ca.4, but it was produced in several variants, differing in factory designations.
Variants
Note: during the war, all these aircraft were designated Ca.4 by the Italian Army. At the time, Caproni referred to the various designs by the total power of their engines. After the war, Caproni devised a new designation scheme for their own design - these are used below.- Ca.40 - single prototype
- Ca.41 - production variant, essentially similar to the prototype and powered by 3 Fiat A.12 inline engines of 281 kW (210 hp). A few Ca.41s were powered by 186 kW (250 hp) Isotta-Fraschini engines instead. These were referred to internally by Caproni as the Caproni 750 hp. 41 built
- Ca.42 - powered by Liberty 298 kW (400 hp) inline engines and known internally as the Caproni 1,200 hp. 12 built
- Ca.43 - single example of a floatplane variant.
- Ca.48 - airliners converted from Ca.42s after the war. Capacity of 23 passengers
- Ca.51 - single example of a considerably enlarged design with biplane tail and tail barbette. 3x 522 kW (700 hp) Fiat A.14 engines
- Ca.52 - Ca.42s built for the RNAS. 6 built
- Ca.58 - Ca.48s re-engined with Fiat A.14 or Isotta-Fraschini V.6
- Ca.59 - as for the Ca.58, but this designation used for customers outside Italy.
Service history
Ca.4s were tested by the Italian Air Force in 1917 and began operations in 1918. They were used for attacking targets in Austro-Hungary. In April 1918, 6 Ca.42s were used by the British RNAS (No. 227 Sqn). At least three CA.42s were sent to the USA for evaluation. After the war, the Ca. 4 was replaced in Italy by the Ca.36.Despite its unstable and fragile appearance, the Ca.4 was well-designed. Its size, without regards to its height, was not any larger than that of other foreign heavy bombers. With Liberty engines, it had a fast speed, similar to other heavy bombers, while its bomb load had one of the largest capacities of that era. If it was flown with other engines, its performance would not have been a spectacular one.
Technical description
Three-engine, twin-boom triplane of a wooden construction, covered with fabric. The open center nacelle was attached to the undersurface of the center wing. It contained the pusher engine, pilot, and forward gunner. At least one variation of the center nacelle seated the crew in a two-seat tandem format with the forward position a gunner/pilot and the rear position the pilot. Others used a forward gunner with side by side pilot positions to the rear of the gunner. Two rear gunners were positioned one in each boom behind the center wing. An engineer or 2nd pilot could also be accommodated there.Armament: 4 (but up to 8) machine guns Revelli 6.5 mm or 7.7 mm in front ring mounting and two boom ring mountings. Bombs were suspended in a bomb bay, which was a long and narrow container fixed to a lower wing. Photographs show at least four different arrangements with regard to the bombing nacelle. 1. No nacelle - presumably not a combat configuration. 2. A tall, narrow nacelle that housed approximately 12 internal bombs vertically and another 18 -20 strapped to the outside. 3. A shorter nacelle that may be the lower half of the tall nacelle but with no external bombs. 4. No nacelle but with a single long bomb/torpedo slung under the bottom wing.
References
- [Caproni Ca.4]
- [AEREI ITALIANI] (Italian)
- [Quest for Performance: The Evolution of Modern Aircraft, Chapter 2: Design Exploration, 1914-18]
Specifications (Caproni Ca.42)
General characteristics
- Crew: five
- Length: 13.10 m (42 ft 11 in)
- Wingspan: 29.90 m (98 ft 1 in)
- Height: 6.30 m (20 ft 8 in)
- Wing area: 200 m² (2,153 ft²)
- Empty: 4,000 kg (8,818 lb)
- Loaded: kg ( lb)
- Maximum takeoff: 7,500 kg (16,534 lb)
- Powerplant: 3x Liberty engines, 298 kW (400 hp) each
Performance
- Maximum speed: 140 km/h (87 mph)
- Range: 700 km (438 miles)
- Service ceiling: 3,000 m (9,845 ft)
- Rate of climb: 125 m/min (410 ft/min)
- Wing loading: kg/m² ( lb/ft²)
- Power/Mass: kW/kg ( hp/lb)
Armament
- 4x 6.5 mm Revelli machine guns, 2 in forward mounting and 1 in each of 2 rearward positions.
- 1,775 kg (3,913 lb) of bombs
Operators
- Italy, United Kingdom, United State.
Related content
Related development:Comparable aircraft:
Designation sequence: Ca.1 - Ca.2 - Ca.3 - Ca.4 - Ca.5
|
Lists of Aircraft | Aircraft manufacturers | Aircraft engines | Aircraft engine manufacturers
| Airlines | Air forces | Aircraft weapons | Missiles | Timeline of aviation |
From Wikipedia, the Free Encyclopedia. Original article here. Support Wikipedia by contributing or donating.
All text is available under the terms of the GNU Free Documentation License See Wikipedia Copyrights for details.