Equalization filter
Encyclopedia : E : EQ : EQU : Equalization filter
An equalization (EQ) filter is a filter, usually adjustable, chiefly meant to compensate for the unequal frequency response of some other signal processing circuit or system.
An EQ filter typically allows the user to adjust one or more parameters that determine the overall shape of the filter's transfer function. It is generally used to improve the fidelity of sound, to emphasize certain instruments, to remove undesired noises, or to create completely new and different sounds.
Equalizers may be designed with peaking filters, shelving filters, or high-pass and low-pass filters.
There are three primary types of equalizers with peaking filters:
- parametric equalizers
- graphic equalizers
- notch filters
- Frequency - All equalizers built on peaking filters use a bell curve which allows the equalizer to operate smoothly across a range of frequencies. The center frequency occurs at the top of the bell curve and is the frequency most affected by equalization. It is often notated as fc and is measured in Hz.
- Q - This is a variable (quality factor) which refers to the width of the bell curve. The higher the Q, the narrower the bandwidth. A high Q means that only a few frequencies are affected, whereas an low Q affects many frequencies.
- The formula for conversion from bandwidth in octaves to Q is:
- [Q = \frac}], where n is the bandwidth in octaves.
- Boost/Cut - Also called gain, this determines how much of the selected frequencies should be present. A boost means that those frequencies will be louder after being equalized, whereas a cut will soften them. The amount of boost/cut or gain is measured decibels, such as +3 dB or -6 dB. A boost or gain of +6 dB generally amounts to the sound being twice as loud after equalization, and most sounds are EQ'd with in the +/- 6 dB range.
A graphic equalizer uses predetermined Q and frequencies which are equally spaced according to the musical intervals, such as the octave (12-band graphic EQ) or one third of an octave (36-band graphic EQ). These frequencies can then be independently boost or cut. This type of EQ is often used for live applications, such as concerts.
A notch filter is an EQ with a very high fixed Q. The frequency and boost/cut remain variable. This kind of EQ is useful in multimedia applications and in audio mastering.
Shelving filters
Shelving filters, unlike those described above, boost or cut from a determined frequency until they reach a preset level which is applied to the rest of the frequency spectrum. This kind of filter is usually found on the treble and bass controls of home audio units. These filters are also used in audio mastering.High pass and low pass filters boost or cut frequencies above or below a selected frequency, called the cutoff frequency. A high pass filter allows only frequencies above the cutoff frequency to pass through unaffected. Frequencies below the cutoff frequency are then attenuated at a constant rate per octave. Low pass filters operate similarly, except that only frequencies below the cutoff are allowed to pass through. Common attenuation rates are 6, 12, and 18 dB per octave. These filters are used to reduce noise and hiss, eliminate pops, and remove rumble. It is common to use a high pass filter (at about 60 - 80 Hz) when recording vocals to eliminate rumble.
Almost all filters (both analog and digital) induce phase shift on the outgoing audio signal, which can cause a problem in mixing. The higher the value of Q, the more this phase shifting occurs. Therefore, EQ is often used sparingly, unless a particular effect is desired.
See also
External links
From Wikipedia, the Free Encyclopedia. Original article here. Support Wikipedia by contributing or donating.
All text is available under the terms of the GNU Free Documentation License See Wikipedia Copyrights for details.